SGC SMARTUNER SG-237 Technical Information download pdf (Page 49)

Mailing: PO Box 3526, Bellevue, WA 98009

Shipping: 13737 SE 26th St., Bellevue, WA 98005

Toll-Free: 800-259-7331 • Phone 425-746-6310 • Fax: 425-746-6384

www.sgcworld.com • Email: sgc@sgcworld.com

base of the antenna

mounted on the

QMS and push

firmly up and

down. The vehicle

should move up

and down, but the

QMS should not. If

the QMS moves

and the vehicle

does not, increase

the tension on the QMS straps.

Removing the QMS. Wash the vehicle in the area around the suction

cups before removing. This will reduce any chance of surface mar-

ring.

• Release suction by applying a rolling sideways motion to the tabs

on the suction cups as shown in the following drawing:

• To make removal of the unit easier, you may slide a piece of paper

between the suction cup and the vehicle surface (see Figure A-3). In

this way, each of the suction cup tabs may be loosened sequentially

as shown:

Storing Your QMS. To store your QMS unit for long periods of time,

apply a thin coating of talcum powder to the suction cups. This treat-

ment increases the life span of rubber products.

Apply silicon grease

to shaded area

Figure A-4—Suction Cup (underside view)

QMS Housing

Suction Cup Release Tabs

SG-237 Manual

page 49

Thursday, July 26, 2001 16:18

Composite

1 2 ... 44 45 46 47 48 49 50 51 52

No comments

SGC SMARTUNER SG-237 Technical Information Page 49